Operation Guide; To Read A Water Or Sewer Tank Level; To Read The Battery Voltage; To Read The Lpg Tank Level (If Equipped) - Garnet SeeLeveL II 709 Series Installation Manual & User Manual

OPERATION GUIDE

The display is the only system component that is accessed by the user. All
user input to the display is done using the buttons along the bottom of the
display. Operation of the display is as follows:

To Read a Water or Sewer Tank Level

1. Press and release button for the
corresponding tank.
2. LED display shows the level in percent.
Display shuts off after about 5 seconds.
3. To read another tank level, battery voltage
or LPG level press that corresponding
button before the 5 seconds is up. The 5
second time-out is restarted every time a
button is pressed.
4. To continuously display reading, press and
release the desired button twice.
5. Continuous display mode is indicated by a
decimal point on the right hand side. The
level is updated once per second. User
can watch the level change while the tank
is being filled or drained.
6. Continuous display mode shuts off after
5 minutes. To end the hold mode sooner,
press any tank button and display will shut
off.
SeeLeveL II 709 Series Display Manual
W NOTE: The model shown is a
709-P3W. Some models may have
different button and switch options.
or or
FRESH GREY BLACK
7 8
LEVEL IN PERCENT LEVEL IN PERCENT
FRESH
or or
BATT LPG
GREY
BLACK
+
FRESH FRESH
7 8 .
LEVEL IN PERCENT
=
+
FRESH
LEVEL IN PERCENT

To Read the Battery Voltage

1. Press and release the BATT button to display
the battery voltage. LED display shows the
battery level in volts.
2. The display shuts off after about 5 seconds.
3. Hold the BATT button and the display will
continuously re-check voltage and show
updated value.
4. The reading may flicker back and forth
between two values, for example, 12.6 and
12.7 volts. This is normal behavior for a
digital voltage display.
5. To read a tank level press the corresponding
button before the 5 seconds is up. The 5
second time-out is restarted every time a
button is pressed.

To Read the LPG Tank Level (if equipped)

1. Press and release the LPG button. Display
shuts off after about 5 seconds.
2. Press and release the LPG again, to display
a new reading. The 5 second timer will be
restarted.
3. Hold the LPG button and reading will remain
displayed.
4. The display will shut off 5 seconds after the
button is released.
5. To read another tank level or battery voltage
press that corresponding button before the 5
second time is up for the LPG. The 5 second
time-out is restarted every time a button is
pressed.
1 2 . 0
BATT
LEVEL IN PERCENT
LEVEL IN PERCENT
1 2 . 6
BATT
LEVEL IN PERCENT
Hold
1 2 . 6 1 2 . 7
LEVEL IN PERCENT LEVEL IN PERCENT
2 3
+
GREY
LEVEL IN PERCENT
5 6
or
LPG
LEVEL IN PERCENT
5 6
LPG
LEVEL IN PERCENT
+
LPG
LPG 5 6
Hold LEVEL IN PERCENT
LEVEL IN PERCENT
7 8
+
GREY
LEVEL IN PERCENT
1 2 . 0
or
BATT
LEVEL IN PERCENT
Page 6