Table Of Contents; Safety Information - Garnet SeeLeveL II 709 Series Installation Manual & User Manual

TABLE OF CONTENTS

Select from contents list below to go to that page.
INTRODUCTION ........................................................................................................................1
SAFETY INFORMATION .......................................................................................................... 2
ABOUT THE SYSTEM ............................................................................................................... 3
Series Model Features Table ..................................................................................................... 4
Model and Serial Number Info ................................................................................................ 4
INSTALLATION INFORMATION ............................................................................................ 4
Installation Documentation Downloads .............................................................................. 4
Tools and Equipment to Install Display ................................................................................ 4
DISPLAY INSTALLATION ......................................................................................................... 5
Display Panel Mounting Template ......................................................................................... 5
Connect Wiring to the Display ................................................................................................ 5
OPERATION GUIDE .................................................................................................................. 6
To Read a Water or Sewer Tank Level ................................................................................... 6
To Read the Battery Voltage ..................................................................................................... 6
To Read the LPG Tank Level (if equipped) ........................................................................... 6
RV-C Bus Communication (if equipped) .............................................................................. 7
NMEA 2000 Network (if equipped) ....................................................................................... 7
CONFIGURATION GUIDE ....................................................................................................... 8
Set the LED Brightness ................................................................................................................ 8
Program the Number of Senders ........................................................................................... 8
Calibrate the LPG Sender (if equipped) ............................................................................... 9
Set tank capacity (709-N2K NLP only) .................................................................................. 9
Calibrate the Battery Voltage ................................................................................................... 9
CONFIGURATION GUIDE (Bluetooth Model Only) .........................................................10
Program Alarm Set Points for Each Tank ...........................................................................10
Trip Polarity....................................................................................................................................10
Inclusion in the Common Alarm Output ...........................................................................10
Failure Polarity (if equipped with LPG) ...............................................................................10
Program the Display as Primary or Secondary ................................................................11
Check the Primary/Secondary Mode ..................................................................................11
Enable/Disable the LPG Sender (if equipped with LPG) ..............................................11
Check Hardware/Software Revision ....................................................................................11
TROUBLESHOOTING GUIDE .................................................................................................12
Error Codes ....................................................................................................................................12
Sender Diagnostics ....................................................................................................................12
RV-C Diagnostics (if equipped) .............................................................................................13
Wiring Diagnostics .....................................................................................................................14
Troubleshooting & Installation Tips ....................................................................................16
WARRANTY & SERVICE INFORMATION ............................................................................18
SeeLeveL II 709 Series Display Manual

SAFETY INFORMATION

Read these instructions carefully and look at the equipment to become
familiar with the device before trying to install, operate, service, or maintain
it. The following special messages may appear throughout this manual
or on the equipment to warn of potential hazards or to call attention to
information that clarifies or simplifies a procedure. "Notes", "Cautions",
and "Warnings" have been used to bring special matters to the immediate
attention of the reader.
Safety Symbols
W
NOTE: expands on information for any procedures.
W
CAUTION: explains safety information that could cause damage to
the product, including data loss.
W
WARNING: explains dangers that might result in personal injury or
death.
Changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment.
Pump and Heater Switch Safety Precaution
W WARNING: All power circuits must be fused. If a fuse is not provided with the system
then it is the installer's responsibility to install a fuse with the maximum rating your model
requires. A relay may be required for models with a pump or heater switch. For
information about the requirements for your model please refer to the Specifications
document located on our website.
For more detailed information please refer to the chapter entitled
TROUBLESHOOTING GUIDE", section "How to avoid damaging the display or pump
switch due to excessive current".
2022 Garnet Instruments. All rights reserved. No part of this publication may be reproduced,
Transmitted, transcribed, stored in a retrieval system or translated into any language in any
form by any means without the prior written consent of Garnet Instruments. Information in this
manual is subject to change without notice and does not represent a commitment on the part
of GARNET.
Page 2