Program The Display As Primary Or Secondary; Check The Primary/Secondary Mode; Enable/Disable The Lpg Sender (If Equipped With Lpg); Check Hardware/Software Revision - Garnet SeeLeveL II 709 Series Installation Manual & User Manual

Program the Display as Primary or Secondary

This setting should normally only need to be done when installing the
gauge. An optional second display can be added to the system. This
allows for a display in the service bay and one inside the coach. To avoid
reading errors when using dual displays, one display needs to be set to
secondary mode. A display in secondary mode monitors the primary
displays sender requests and will only scan the tank levels at a much
slower rate if the primary display is disconnected. The alarms are inactive
on the secondary display. All RVC displays are primary by default.
To program a display to be either primary or secondary display:
1. With power removed, press and hold the
BATT and FRESH buttons and then power
the display.
2. The display will show "Scn" for 5 seconds,
then change to "SEC" or "Pri" depending on
current programming.
3. The FRESH button sets the mode to PRIMARY
the GREY button to SECONDARY
the BATT button saves and exits.

Check the Primary/Secondary Mode

1. Press and hold down the BATT button, the
display will show the battery voltage.
2. While continuing to hold down the BATT
button, press and hold down the BLACK
button.
3. Continue to hold down both buttons for
about 5 seconds until the display shows
"Pri" for primary mode or "SEC" for
secondary mode. When viewing is complete,
release both buttons to return to normal
operation.
SeeLeveL II 709 Series Display Manual
BATT +
FRESH
S c n S E C
LEVEL IN PERCENT LEVEL IN PERCENT
P r i
LEVEL IN PERCENT
FRESH GREY
BATT
BATT 1 2 . 0
Hold
LEVEL IN PERCENT
+
BLACK
Hold
P r i S E C
or
LEVEL IN PERCENT LEVEL IN PERCENT

Enable/Disable the LPG Sender (if equipped with LPG)

The LPG sender can only be disabled from the primary display of
RVC and Bluetooth models. If these steps are used on the secondary
display, no change will result.
1. Press and hold down the LPG button.
2. While continuing to hold down the LPG
button, press and hold down the BATT
button. Continue to hold down both buttons
for about 10 seconds until the display shows
"AbL".
3. When this occurs release both buttons, the
display will show "En" for enabled or "diS"
for disabled.
4. Press the LPG button to switch between
enabled and disabled.
5. Press the BATT button to save and exit the
menu.

Check Hardware/Software Revision

Hardware and software updates may be periodically released to add
features. To check the hardware and software version of the display, use
the following procedure.
1. Press and hold down the BATT button, the
display will show the battery voltage.
2. While continuing to hold down the BATT
button, press and hold down the FRESH
button.
3. Continue to hold down both buttons for
about 5 seconds until the display shows a
number such as "4.10", the first number is the
hardware version and the last two numbers
are the software version. When viewing is
complete, release both buttons to return to
normal operation.
+
LPG
Hold
+
A b L
BATT
LEVEL IN PERCENT
Hold
E n d i 5
or
LEVEL IN PERCENT LEVEL IN PERCENT
L P G
LEVEL IN PERCENT
BATT
1 2 . 0
BATT
LEVEL IN PERCENT
Hold
+
FRESH
4 . 1 0
LEVEL IN PERCENT
Page 11