Table of Contents
Advertisement
EasySet Programming
in Icons
Your Detector
Intro
Operation
Customer
Warranty
EasySet Programming
Assistance
All user mode settings on your detector can be changed by using
Program mode. When changing the settings, please keep in mind:
Intro
Operation
Customer
Warranty
Assistance
Buttons can have multiple functions.
Secondary Icons
All settings will be stored in memory when the power is
turned Off and recalled when the power is turned back On.
condary Icons
The procedure for using Program mode is shown on page 7.
in Icons
NOTE
Notice
You cannot enter Program mode during an alert. The unit will not
Notice
detect signals while in Program mode. During programming, if no
buttons are pushed for ten seconds, the unit will automatically exit
Intro
Operation
Customer
Warranty
Assistance
Program mode and save the last settings.
Programming User Modes
The tables on pages 8 through 9 show you how to program all user modes
condary Icons
and the settings you can choose from.
NOTE
On the following pages, you will find more detailed explanations
Notice
of each setting.
See page 14 for instructions on setting the IntelliMute activation point.
See page 17 for instructions on calibrating the compass.
See page 22 for instructions on using SmartPower.
6
English
EasySet Programming
Your Detector
Intro
Operation
Customer
Warranty
Assistance
•
Secondary Icons
To Use Program Mode
Press and hold the
Tone
Program/Mute button
Notice
Three beeps
for two seconds.
While the programming
One beep with
instructions are
each button press
scrolling, press and
release the Select/Dim
button to cycle through
the user modes.
With the user mode you
One or two beeps,
wish to change displayed,
depending on your
press and release the
selection
Set/City button to
change the setting.
To move to the next
selection, press the
Select/Dim button again.
When you have finished
One beep
programming any or
all of the user modes,
press and release the
Program/Mute button
to exit Program mode.
Or simply wait ten
seconds without
pushing any buttons.
Set/City Button
Press and release
Select/Dim Button
Press and release
Program/Mute Button
Press and hold/Press and release
Visual Display
Program will appear.
P R O G R A M
Then brief programming
instructions will scroll through
the display three times.
As each mode is displayed,
the current setting for that
mode will be shown.
The setting you select will
be shown.
When you exit Program
mode, the new setting will
automatically be saved and
EXIT PROGRAM and Settings
Saved! will appear in the display.
EX I T
S et ti n g s
P R O G R A M
S av ed !
Nothing Comes Close to a Cobra
®
7
Advertisement
Table of Contents
