Table of Contents
Advertisement
Settings
Your Detector
Intro
Operation
Customer
Warranty
IntelliMute Pro
Assistance
IntelliMute Pro prevents detection by radar detector detectors (RDDs) such
as VG-2, Spectre I and Spectre IV+ when traveling at slower speeds. It is
intended for use by experienced users only.
Operation
Secondary Icons
Customer
Warranty
When IntelliMute Pro is turned On, and engine RPMs are below the IntelliMute
Assistance
activation point, your detector's radar detection circuits are turned Off to
prevent detection by RDDs.
Customer
Before IntelliMute Pro can be turned On, you must have turned On and Set
Installation
Assistance
the IntelliMute activation point. (See pages 13 through 15.)
Notice
CAUTION
When IntelliMute Pro is On, NO radar signals will be detected and
NO alerts will be given at RPMs below the IntelliMute activation point.
Notice
Caution
Warning
To Turn IntelliMute Pro On or Off Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode,
Tone
go to IntelliMute Pro.
Two beeps
One beep
IntelliMute Pro On
IntelliMute Pro Off
Intelli
Intelli
Mute Pro
Mute Pro
On
Off
N W
i h
N W
16 English
Main Icons
Your Detector
Intro
Compass
Your detector includes an internal
Intro
Operation
8-point Compass that will continuously
display your current direction of travel:
N, NE, E, SE, S, SW, W or NW.
Secondary Icons
Secondary Icons
Calibrating the Compass
NOTE
Before using it for the first time, you must calibrate the compass to
Notice
provide accurate indications of direction. See page 7 for instructions
on using the Program mode to select Set Compass.
Calibration allows the compass electronics to measure and store
Main Icons
information about the magnetic fields generated by your vehicle.
The compass will remain accurately calibrated as long as your detector is
mounted in the same place in your vehicle. If you change the location where
Visual Display
the unit is mounted or move it to another vehicle, you must recalibrate the
Intro
Operation
IntelliMute Pro On,
compass.
then i blinks in the display
The compass temporarily may not provide accurate readings if you are inside
IntelliMute Pro Off,
a building or enclosure, or are close to a large metal tractor/trailer, truck, or
then i is steady in the display
train. Once you are away from such a location, the compass will work
Secondary Icons
correctly again.
NOTE
When the instructions direct you to drive in two circles, a large parking
lot is the most convenient place to do so. It does not matter what
Notice
direction your vehicle is pointing when you start the circles, which
direction you go to make the circles, and it does not have to be exactly
two circles. You do NOT have to make perfect circles. You can drive in
any pattern, as long as you make two complete turns. Four three-point
turns, two small squares, or any two complete loops will work as well as
i h
two circles. It does not matter what size the circles are, if your speed is
constant, or how fast you make the circles [but less than two minutes].
Please be careful when making the circles and watch for other traffic.
Settings
Operation
Customer
Warranty
Assistance
N
NW
NE
Customer
Warranty
Assistance
8-Point
W
Compass
SW
SE
S
Notice
Customer
Warranty
Assistance
Nothing Comes Close to a Cobra
E
®
17
Advertisement
Table of Contents
