Easyset Programming - Cobra 15 BAND XRS 970 Operating Instructions Manual

EasySet Programming

Your Detector
EasySet Programming
All user mode settings on your detector can be changed by using
Program mode. When changing the settings, please keep in mind:
Buttons can have multiple functions.
All settings will be stored in memory when the power is
turned Off and recalled when the power is turned back On.
The procedure for using Program mode is shown on page 7.
NOTE
You cannot enter Program mode during an alert. The unit will not detect
signals while in Program mode. During programming, if no buttons are
pushed for ten seconds, the unit will automatically exit Program mode and
save the last settings.
Programming User Modes
The tables on pages 8 through 9 show you how to program all user modes and the
settings you can choose from.
NOTE
On the following pages, you will find more detailed explanations
of each setting.
See page 15 for instructions on setting the IntelliMute activation point. See
page 18 for instructions on calibrating the compass.
See page 23 for instructions on using SmartPower.
English
6
Your Detector
•
To Use Program Mode
Press and hold the
Program/Mute button
for two seconds.
While the programming
instructions are scrolling,
press and release the
Select/Dim button to
cycle through
the user modes.
With the user mode you
wish to change displayed,
press and release the
Set/City button to change
the setting.
To move to the next
selection, press the
Select/Dim button again.
When you have finished
programming any or
all of the user modes,
press and release the
Program/Mute button
to exit Program mode.
Or simply wait ten
seconds without
pushing any buttons.
EasySet Programming
Tone Visual Display
Program will appear.
Three beeps
PROGRAM
Then brief programming
instructions will scroll through
the display three times.
One beep As each mode is displayed,
with each the current setting for that
button press mode will be shown.
One The setting you
or two beeps, select will be shown.
depending
on your
selection
One beep When you exit Program mode,
the new setting
will automatically be saved
and EXIT PROGRAM and
Settings Saved! will appear.
EXIT
Settings
PROGRAM Saved!
Nothing Comes Close to a Cobra
Set/City Button
Press and release
Select/Dim Button
Press and release
Program/Mute Button
Press and hold/Press and release
Voice
Start Program
None
Current setting
Exit Program
7
®