Intellimute; Customer Assistance - Cobra XRS 9645 Operating Instructions Manual

Settings
Your Detector
Intro Operation Customer Warranty
What to Remember While Using IntelliMute Assistance
IntelliMute works with all City and Auto Mute modes.
Whenever engine revs are below the activation point, an arrow
pointing down will appear in the display. Above the activation point,
in Icons
Secondary Icons
an arrow pointing up will appear.
Below Activation Point Above Activation Point
in Icons
N W i h N W i h
Intro Operation Customer Warranty
Assistance
Notice
If, for any reason, the unit stops sensing your engine's revs,
IntelliMute will indicate an error and automatically turn Off.
Intro Operation Customer Warranty
Assistance
The rev point you set will be stored in the unit's memory when
condary Icons
power is turned Off and recalled each time the power is turned On.
NOTE
condary Icons
The rev point must be reset if you use your detector in a different vehicle.
Notice
NOTE
When initially choosing your IntelliMute activation point, a setting
Notice of approximately 300 to 600 RPMs above idle is recommended.
Operation Customer Warranty
Assistance
You can reset the activation point at any time to fit your individual
preferences and driving style.
Setting the IntelliMute Activation Point
Customer
Installation
Assistance
Your detector must be installed in your vehicle.
CAUTION
Do not attempt to set the rev point while driving.
Your vehicle should be parked and idling.
Notice Caution Warning
IntelliMute must be turned On before setting the activation point.
14 English
Settings
Your Detector
Intro Operation Customer Warranty
Assistance
Select/Dim Button
Program/Mute Button
Secondary Icons
To Set the IntelliMute Activation Point Using Program Mode
(See Page 7 For Instructions on Using Program Mode)
In Program mode, go to Set
Tone

IntelliMute.

None
Press and release the Set/City button Notice Two beeps
to begin setting IntelliMute RPMs.
Rev your engine to the level you wish to None
set. Rev the engine slightly above idle and
hold revs steady for two seconds.
Main Icons
At the desired rev level, press and Three beeps
release the Set/City button.
Press and release either the None
Select/Dim button to proceed to the
Intro Operation Customer Warranty
next user mode or the Program/Mute
Assistance
button to exit the Program mode.
Setting IntelliMute RPMs
Secondary Icons
Set Intel... Press SET...
NOTE
If the unit is unable to sense usable pulses
Notice
within three seconds or if you do not set a
rev point within 20 seconds of beginning
these steps, IntelliMute will indicate an
error and automatically turn Off.
Tone Visual Display
One beep IntelliMute not set
Please try again
One beep IntelliMute Off
Set/City
Button
Visual Display
Set IntelliMute
Press SET at
desired RPMs...
None
IntelliMute Set!
None
Intelli
Mute
Set!
IntelliMute IntelliMute Off
Not Set
I n tel l i
In te l l i M u .. .
M u te
P l e ase tr. ..
O f f
Nothing Comes Close to a Cobra ® 15