Table of Contents
Advertisement
9495 XRS 9630-D-B2
4/10/06
EasySet Programming
Your Detector
EasySet Programming
All user mode settings on your detector can be changed by using
Program mode. When changing the settings, please keep in mind:
■
Buttons can have multiple functions.
■
All settings will be stored in memory when the power is
turned off and recalled when the power is turned back on.
The procedure for using Program mode is shown on page 7.
NOTE
You cannot enter Program mode during an alert. The unit will not detect
signals while in Program mode. During programming, if no buttons are
pushed for ten seconds, the unit will automatically exit Program mode
and save the last settings.
Programming User Modes
The tables on pages 8 through 9 show you how to program all user modes
and the settings you can choose from.
NOTE
On the following pages, you will find more detailed
explanations of each setting.
See page 14 for instructions on setting the IntelliMute activation point.
See page 16 for instructions on calibrating the compass.
See page 21 for instructions on using SmartPower.
6
English
11:59 AM
Page 6
Your Detector
Set/City Button
•
Press and release
Press and hold/Press and release
To Use Program Mode
Press and hold the
Program/Mute button
for two seconds.
While the programming
instructions are
scrolling, press and
release the Select/Dim
button to cycle through
the user modes.
With the user mode you
wish to change displayed,
press and release the
Set/City button to
change the setting.
To move to the next
selection, press the
Select/Dim button again.
When you have finished
programming any or
all of the user modes,
press and release the
Program/Mute button
to exit Program mode.
Or simply wait ten
seconds without
pushing any buttons.
EasySet Programming
Select/Dim Button
Press and release
Program/Mute Button
Tone
Visual Display
Three beeps
Program will appear.
PROGRAM
Then brief programming
instructions will scroll through
the display three times.
One beep with
As each mode is displayed,
each button press
the current setting for that
mode will be shown.
One or two beeps,
The setting you select will
depending on your
be shown.
selection
One beep
When you exit Program
mode, the new setting will
automatically be saved and
EXIT PROGRAM and Settings
Saved! will appear in the display.
EXIT
PROGRAM
Nothing Comes Close to a Cobra
Settings
Saved!
®
7
Advertisement
Table of Contents
