Table of Contents
Advertisement
EasySet Programming
Your Detector
EasySet Programming
All user mode settings on your detector can be changed by using
Program mode. When changing the settings, please keep in mind:
Buttons can have multiple functions.
I
All settings will be stored in memory when the power is
I
turned Off and recalled when the power is turned back On.
The procedure for using Program mode is shown on page 7.
NOTE
You cannot enter Program mode during an alert. The unit will not detect
signals while in Program mode. During programming, if no buttons are
pushed for ten seconds, the unit will automatically exit Program mode
and save the last settings.
Programming User Modes
The tables on pages 8 through 9 show you how to program all user modes
and the settings you can choose from.
NOTE
On the following pages, you will find more detailed explanations
of each setting.
See page 15 for instructions on setting the IntelliMute activation point.
See page 18 for instructions on calibrating the compass.
See page 23 for instructions on using SmartPower.
English
6
EasySet Programming
Your Detector
•
To Use Program Mode
Press and hold the
Tone
Program/Mute button
Three beeps
for two seconds.
While the programming
One beep
instructions are
with each
scrolling, press and
button press
release the Select/Dim
button to cycle through
the user modes.
With the user mode you
One
wish to change displayed,
or two
press and release the
beeps,
Set/City button to
depending
change the setting.
on your
selection
To move to the next
selection, press the
Select/Dim button again.
When you have finished
One beep
programming any or
all of the user modes,
press and release the
Program/Mute button
to exit Program mode.
Or simply wait ten
seconds without
pushing any buttons.
Set/City Button
Press and release
Select/Dim Button
Press and release
Program/Mute Button
Press and hold/Press and release
Visual Display
Voice
Program will appear.
Start Program
P RO GRAM
Then brief programming
instructions will scroll
through the display three
times.
As each mode is displayed,
None
the current setting for that
mode will be shown.
The setting you
Current
select will be shown.
setting
When you exit Program
Exit Program
mode, the new setting
will automatically be saved
and EXIT PROGRAM and
Settings Saved! will appear.
EX I T
Se tti n g s
P ROGRA M
S a v ed!
Nothing Comes Close to a Cobra
®
7
Advertisement
Table of Contents
