Emerson LOFT CF765BQ01 Owner's Manual page 6

3. Ceiling Fan Assembly
3.3
Route the Two 80" Motor Wires through the center hole
in the Motor Cover.
Place the Motor Cover over the Motor by aligning the
Reverse Switch Hole in the Cover over the Reverse
Switch, as shown in Figure 3.
Secure by installing Three #10-24 x 10mm Pan Head
Screws with Lockwashers (supplied) (Figure 3).
3.4
Remove the Hanger Ball by loosening the Phillips Head
Set Screw in the Hanger Ball until the Ball falls freely
down the Downrod (Figure 4).
Remove the Pin from the Downrod, then remove the
Hanger Ball (Figure 4).
Retain the Pin and Hanger Ball for reinstallation in
Step 3.10.
(Continued)
#10-24 x 10mm PAN
HEAD SCREW WITH
LOCKWASHER (3)
MOTOR COVER
MOTOR COVER
REVERSE SWITCH
HOLE
REVERSE
SWITCH
Figure 3
PIN
GREEN GROUND WIRE SCREW
PHILLIPS HEAD SET SCREW (LOOSENED)
Figure 4
6
GREEN GROUND WIRE
6" DOWNROD
HANGER BALL
U.L. Model No.: CF765-1