Table of Contents
Advertisement
Chapter
Back Panel
The Access Point's Reset button and ground are located
on the back panel.
Back Panel
Reset Button
There are two ways to Reset the Access
Point's factory defaults. Either press the Reset button, for
approximately ten seconds, or restore the defaults using
the Access Point's web-based utility.
IMPORTANT:
Resetting the Access Point will
erase all of your settings (including wireless
security, IP address, and power output) and
replace them with the factory defaults. Do not
reset the Access Point if you want to retain these
settings.
Ground
Before you mount the Access Point, you must
ground the Access Point (to a large piece of metal) as a
precaution against electric shock.
Wreless-G Exteror Access Pont wth Power Over Ethernet
Reset button
Ground
The Antenna Pattern
The Wireless-G Exterior Access Point uses 1X2 MIMO (1Tx,
2Rx) so it has two built-in antennas. The right antenna is
the main antenna for Tx traffic. When an external antenna
is attached, the right antenna is disabled and the external
antenna is used for Tx traffic. Currently, only the HGA9N
(9dBi omni-directional antenna) is compatible with the
Wireless-G Exterior Access Point.
Right Antenna Pattern
3dB BW: 50 degree, peak gain: 6.3 dBi
Left Antenna Pattern
3dB BW: 63 degree, peak gain: 4.9 dBi
Product Overview
Advertisement
Table of Contents
