Table of Contents
Advertisement
Chapter
receive notification of any critical events as they occur on
the Access Point.
To enable the SNMP support feature, select Enabled.
Otherwise, select Dsabled. The default is Dsabled.
Identification
Contact
Enter the name of the contact person, such as a
network administrator, for the Access Point.
Devce Name
Enter the name you wish to give to the
Access Point.
Locaton
Enter the location of the Access Point.
Get Communty
Enter the password that allows read-
only access to the Access Point's SNMP information.
Set Communty
Enter the password that allows read/
write access to the Access Point's SNMP information.
SNMP Trap-Communty
Enter the password required by
the remote host computer that will receive trap messages
or notices sent by the Access Point.
SNMP Trusted Host
You can restrict access to the Access
Point's SNMP information by IP address. Enter the IP
address in the field provided. If this field is left blank, then
access is permitted from any IP address.
SNMP Trap-Destnaton
the remote host computer that will receive the trap
messages.
Change these settings as described here and click Save
Settngs to apply your changes, or click Cancel Changes
to cancel your changes. Help information is displayed
on the right-hand side of the screen, and click Help for
additional details.
Administration > Log
On this screen you can configure the log settings and
alerts of particular events.
Administration > Log
Wreless-G Exteror Access Pont wth Power Over Ethernet
Enter the IP address of
Advanced Configuration
Log
You can have logs that keep track of the Access Point's
activities.
Email Alert
E-Mal Alert
If you want the Access Point to send e-mail
alerts in the event of certain activities, select Enabled. The
default is Dsabled.
E-Mal Address for Logs
Enter the e-mail address that
will receive logs.
Notification Queue Length
Log Queue Length
You can designate the length of the
log that will be e-mailed to you. The default is 20 entries.
Log Tme Threshold
You can designate how often the
log will be emailed to you. The default is 600 seconds (10
minutes).
Syslog Notification
Syslog is a standard protocol used to capture information
about network activity. The Access Point supports this
protocol and sends its activity logs to an external server. To
enable Syslog, select Enabled. The default is Dsabled.
Syslog Server IP Address
Syslog server. In addition to the standard event log, the
Access Point can send a detailed log to an external Syslog
server. The Access Point's Syslog captures all log activities
and includes this information about all data transmissions:
every connection source and destination IP address, IP
server, and number of bytes transferred.
Log
Select the events that you want the Access Point to keep
a log.
Unauthorzed Logn Attempt
alert logs about any unauthorized login attempts, click
the checkbox.
Authorzed Logn
If you want to log authorized logins,
click the checkbox.
System Error Messages
If you want to log system error
messages, click the checkbox.
Confguraton Changes
If you want to log any
configuration changes, click the checkbox.
Change these settings as described here and click Save
Settngs to apply your changes, or click Cancel Changes
to cancel your changes. Help information is available on
the right side of the screen.
Enter the IP address of the
If you want to receive
0
Advertisement
Table of Contents
