Table of Contents
Advertisement
Chapter
Administration > Factory Default
On this screen you can restore the Access Point's factory
default settings.
Administration > Factory Default
Factory Default
Note any custom settings before you restore the factory
defaults. Once the Access Point is reset, you will have to
re-enter all of your configuration settings.
Restore Factory Defaults
factory default settings, click the Yes radio button. Then,
click Save Settngs. Your Access Point will reboot and
come back up with the factory default settings in a few
seconds.
Click Save Settngs to apply your change, or click Cancel
Changes to cancel your change. Help information is
available on the right side of the screen.
Administration > Firmware Upgrade
On this screen you can upgrade the Access Point's firmware.
Do not upgrade the firmware unless you are experiencing
problems with the Access Point or the new firmware has a
feature you want to use.
Wreless-G Exteror Access Pont wth Power Over Ethernet
To restore the Access Point's
Advanced Configuration
Administration > Firmware Upgrade
Firmware Upgrade
Before you upgrade the Access Point's firmware, note all of
your custom settings. After you upgrade its firmware, you
may have to re-enter all of your configuration settings. To
upgrade the Access Point's firmware:
1.
Download the firmware upgrade file from the Linksys
website, www.linksys.com.
2.
Extract the firmware upgrade file on your computer.
3.
On the Firmware Upgrade screen, enter the location of
the firmware upgrade file in the field provided, or click
the Browse button to find the file.
4.
Click the Upgrade button, and follow the on-screen
instructions.
Help information is available on the right side of the
screen.
Advertisement
Table of Contents
