The Back Panel; Figure 3-2: Back Panel - Linksys wap54g Quick Installation Manual

Wireless-G Access Point

The Back Panel

The Access Point's Ethernet network and power ports, as well as the Reset button, are located on the back panel.
LAN Port The Ethernet network port connects to an Ethernet network device, such as a switch or router.
Reset Button There are two ways to reset the Access Point's factory defaults. Either press the Reset button,
for approximately ten seconds, or use the Administration - Factory Defaults screen of the
Access Point's Web-based Utility.
IMPORTANT: Resetting the Access Point will erase all of your settings
(including wireless security, IP address, and power output) and replace them
with the factory defaults. Do not reset the Access Point if you want to retain
these settings.
Power Port The Power port connects to the Access Point's power adapter.
Chapter 3: Getting to Know the Wireless-G Access Point
The Back Panel

Figure 3-2: Back Panel

port: the connection point on a computer or
networking device used for plugging in
cables or adapters
7