Table of Contents
Advertisement
3-38
V
*L
ARI
ITE®
Figure 3-3. Blue/Amber Bulkhead Assembly Sensor Removal and Replacement
CONFIDENTIAL
- VL4™ W
L
ASH
UMINAIRE
Step 4.
Prepare replacement sensor.
a. At replacement sensor assembly, using needle-nosed pliers,
bend unused sensor lead to 45 degree angle.
b. Trim sensor assembly wires to 15 inches.
CAUTION: To avoid poor connections, do not reuse MTA connector
from removed sensor on replacement sensor.
c. Using MTA crimper, crimp wires into new 4-pin MTA
connector using the following pinouts:
d. Install strain relief cover on 4-pin connector. Using
permanent ink marker, mark strain relief either BLUE or
AMB as necessary.
CAUTION: Do not overtighten nuts when installing replacement sensor.
e. Install replacement sensor and re-install blue/amber
bulkhead by doing Steps 2 and 3 in reverse.
S
M
ERVICE
ANUAL
Pin
Wire
4
Blue
3
Blue
2
N/C
1
N/C
SENSOR
2-56 NYLON INSERT
STOP LOCK NUT
CABLE ANCHOR
REFLECTOR
BATOP
02.9628.0010
7-Oct-97
Advertisement
Table of Contents
