VARILITE VL4 Manual page 153

TILT FLANGE
TAPE 26-PIN CONNECTOR
TO END OF VERY LONG
TIE WRAP
Figure 3-44. Yoke Cables and Lamp Wire Replacement
02.9628.0010
7-Oct-97
Figure 3-43. Yoke Cables and Lamp Wire Removal
Step 18. Install replacement yoke cable or lamp wire.
a. At replacement yoke cable or lamp wire, tape one connector
to very long cable tie. Tape connector to cable tie so that
connector's short side faces forward
(Figure 3-44).
INSERT END INTO PAN TUBE
AND UP INTO TILT TUBE.
PULL TIE WRAP THROUGH
b. Insert untaped end of cable tie into pan tube from yoke
bearing frame side. Push cable tie thru yoke until cable tie is
visible thru tilt tube in luminaire head.
c. Pull cable tie (with yoke cable) thru tilt tube until connector
extends thru tilt tube.
C 3. M
HAPTER
SPRING
YOKE CABLES AND
LAMP WIRE
CABLE ANCHOR
P
AINTENANCE ROCEDURES
TURN 26-PIN CONNECTOR
AND INSERT IN TILT TUBE
SMALL END FIRST
CABLE SIDE RAIL
3-107
CABLVW
CONFIDENTIAL