Table of Contents
Advertisement
3-36
V
*L
ARI
ITE®
STEPPER MOTORS
MOTOR MOUNT
4-40 KEPS NUT
Figure 3-2. Blue/Amber Bulkhead Stepper Motor Removal and Replacement
CONFIDENTIAL
- VL4™ W
L
ASH
UMINAIRE
Step 5.
Install replacement motor assembly and re-install blue/amber
bulkhead by doing Steps 2 thru 4 in reverse.
a. Apply small amount of Versilube to both motor worm gears
and make sure that worm wheels are aligned properly on
drive shaft so that they engage worm gears in center.
b. If during replacement motor mount bushing or bearing
comes loose, place bead of Superbonder 498 glue around
bushing flange and fully reseat bushing in motor mount.
Allow 15 minutes for glue to dry before re-installing motor
mount.
S
M
ERVICE
ANUAL
APPLY SUPERBONDER 498
AROUND BEARINGS IF LOOSE
1 INCH CONTINUOUS
GROMMET (REFLECTOR SIDE)
02.9628.0010
7-Oct-97
Advertisement
Table of Contents
