Advertisement
2
FIT AND SECURE
2.7
3
FIT AND SECURE
2.1
2.4
3.1
Refer to RRSTUNI when assembling your Slimline II Tray.
3.2
3.3
2.2
3.4
Centre the rack and fully tighten . Use M8 nut caps (Items 10) to finish off the nuts.
FATT002_REV_A01
4
Place the side rails onto the vehicle,
lining up the holes in the base of the
side rails with the aluminium spacers.
There is a left and a right hand side rail.
The product sticker must be on the front
10mm
outer side of the vehicle.
Hand tighten the foot rails to the roof
using the M6x35 hex bolts (item 3) M6
spring washers and M6x19x1 flat
washers supplied.
Measure the distance from the top of the
10mm
windscreen to the first hole in each rail.
Ensuring that the left and right hand
sides are of equal distance. Fully tighten
the bolts. Use M6 nut caps (Items 2) to
finish off the nuts.
4MM
Make sure that the wind diflector is
installed before you proceed to the next
step.
Slide item 7 into the t-slots shown in
step 3.3. Loosely fit the rack to the foot
rail by using items 7, 8 and 9.
13mm
13mm
5
© COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS
Advertisement
