Front Runner FATT002 Quick Start Manual page 3

2 FIT AND SECURE
2.1
2.2
2.3
FATT002_REV_A01
Using a flat screwdriver, starting from
the front of the vehicle, lift and remove
the two ditch moldings running along
either side of the roof.
Remove the tape covering the ten
mounting points in the gutter(five on
each side). Insert and hand tighten the
ten M6x35 hex bolts (item 3) supplied to
the mounting pionts.
Starting at the front of the vehicle, refit
the ditch molding. Whenever you reach
one of the hex bolts that you have
inserted, take a white marking pen and
mark the top of the hex bolt. While the
white "paint" is still wet press the ditch
molding onto the head of the bolt,
transferring the position of the bolt head
onto the underside of the ditch molding.
Repeat this process for all the bolts on
both ditch moldings.
Working on the underside of the ditch
molding, measure and mark a line 15mm
either side of your original markings
from Step 2.1 as shown in 2.2.
Using a pair of side cutters and a utility
knife, remove the marked section of
ditch molding as shown in
Step 2.2 through to Step 2.4.
Refer to step 2.2.
3 © COPYRIGHT 2016 FRONT RUNNER VEHICLE OUTFITTERS
13mm