Advertisement
TOYOTA
Checklist - these points MUST be checked to ensure a quality installation.
Check:
Accessory Function Checks
Verify parts
Vehicle Startup
Power LEDs light up.
Vehicle Function Checks
Standard exterior lights - low/high beams,
left/right turn signal, emergency signal.
Roof console functions- map lights,
sun/pano roof (if equipped), trunk release,
rear dimming mirrors.
TPMS gauge indicator
Vehicle Appearance Check
After accessory installation and removal of
protective cover(s), perform a visual
inspection.
Issue: D 4/14/2021
VENZA
Page 11 of 11 pages
2021 -
Dashcam (Digital Video Recorder)
Look For:
Removed items have been discarded &
replaced items are in place
Confirm Dashcam does not emit continuous
beep on vehicle startup. If it does, confirm
SD card is installed.
Confirm standard lighting functions work
properly.
Confirm roof functions work properly.
Prior to TPMS activation and PDS, the
TPMS light may blink when IG is on. After
activation and PDS, the TPMS light should
turn off when IG is on.
Ensure no damage (including scuffs and
scratches) was caused during the
installation process.
(For PPO installations, refer to TMNA
Accessory Quality Shipping Standard.)
Confirm windshield template has been
removed from vehicle.
DIO
Advertisement
