Table of Contents
Advertisement
BD-VOIP-128S User Manual
RTP Start Port
UDP Checksum Validation
DTMF Method
RFC2833 Payload Type
Preferred (Incoming Call)
RFC2833 Payload Type
DTMF Gain
DTMF Send Interval
Send Flash Event
Send
Analog
Active
Coder Name
Payload Type
Packetization Time
Rate
Silence Suppression
Codecs Preferred
4.10.4
Service Parameter
Service parameters include tiemout for dialing, digitmap,MWI message and so on.
Website: www.baudcom.com.cn
When 'Use Random Port' is not selected, you need to configure
a start port for RTP. Default RTP start port is 8000
Choose whether to enable header checksum of UDP
Include SINGAL, INBAND and RFC2833
For an incoming call, choose local or remote RFC2833 payload
type as the preferred payload type
Local payload value, default value is 101
Default value is 0 DB
The interval for sending DTMF signal. The default value is
200ms.
If this parameter is enabled, the BD-VOIP-128S device will
send flash-hook event to remote terminal, and thus user does not
need to handle it locally
DTMF
Tone
to
If this parameter is enabled, DTMF tone will be sent to analog
When
Call
in
phone when there is a call
The
G.726-16/24/32/40. When outgoing calls are made, G.729 will
be used.
Each kind of coding has a unique load value, refer to RFC3551.
The time for voice packaging
Voice data flow rate; It is defaulted by system.
Default value is 'disabled'. If this parameter is enabled, VoIP
transmission bandwidth can be saved, and meanwhile network
congestion can be avoided.
Choose local or remote codec as the preferred codec
device
supports
Email:
info@baudcom.com.cn
4 Configurations on Web Interface
G.729,
G.711U,
G.711A,
G.723,
41
Advertisement
Table of Contents
