Table of Contents
Advertisement
BD-VOIP-128S User Manual
FAX Parameter
Fax Mode
Include "a=X-fax"
Attribute
Include "a=fax"
Attribute
Include "a=X-modem"
Attribute
Include "a=modem"
Attribute
ECM
Rate
Tone Detection by
Switch into Fax Mode
When Detect CNG or
CED
4.10.2
FXS Parameter
On the Advanced FXS/FXO page, you can configure FXS parameters which include send
polarity reversal, detect hook flash, CID type and so on.
Website: www.baudcom.com.cn
PSTN to IP(TX): adjust gain value from analog phone
The BD-VOIP-128Sdevice supports the three fax modes: T.38
(IP-based), T.30 (Pass-Through) and Adaptive Fax Mode
(automatically match with the peer fax mode).
There are three fax modes: T.38, T.30(Pass-through), and
Adaptive.
If this parameter is enabled, "a=X-fax" attribute will be carried
in SDP
If this parameter is enabled, "a=fax" attribute will be carried in
SDP
If this parameter is enabled, "a=X-modem" attribute will be
carried in SDP
If this parameter is enabled, "a=modem" attribute will be carried
in SDP
Whether to enable 'Error Correction Mode'（ECM）.
The rate of sending or receiving fax, default value is 14400bps.
Fax sound is detected by caller, callee or automatically.
If this parameter is enabled, the system will switch into fax
mode when CNG or CED is detected.
Email:
info@baudcom.com.cn
4 Configurations on Web Interface
38
Advertisement
Table of Contents
