Pure Ip Netware 5.X Setup - Linksys EFSP42 User Manual

Before You Begin
At this point, you must have:
• The PrintServer hardware completely installed.
• Your NetWare network fully operational.
• Administrator or Supervisor rights on the file server(s), or be logged on as
an Administrator or Supervisor.
• Access to your server's administrative utilities like NWADMIN
and PCONSOLE.
• the PrintServer Setup CD in the CD-ROM drive.
To begin the installation, choose a mode of printing operation and turn to the
correct page for instructions:
• for NetWare 5.x
Pure IP Printing Mode, see page 31
N N o o t t e e : To set up DHCP on the PrintServer, install B B i i - - A A d d m m i i n n first (see page
37), then install D D H H C C P P (see page 57), and install the printer driver last. This
applies to pure IP NetWare under the 5.x version only.
• for NetWare 5.x, 4.x, 3.x
IPX Printing Mode:
- Print Server Mode, see page 35
- Remote Printer Mode, see page 36
30
Instant EtherFast ® Series EtherFast 10/100 PrintServers

Pure IP NetWare 5.x Setup

These instructions set up the PrintServer to work in a pure IP NetWare 5.x
environment. Consider the following example:
Tree Name: Novell
Organization: TeSupp
CN: Admin.TeSupp
Server Name: TECH_50
CD-ROM Drive: D
PrintServer IP: 192.168.0.3
Throughout the directions, replace these settings with your own, since these
parameters are given as an example only. To set up IP addresses, see page 58.
To enable printing from your PrintServer on a pure IP NetWare 5.x network:
• First, create a NDPS Manager on your server. This only needs to be done
once, even if you create more than one NDPS printer.
• Create NDPS printers with NetWare Administrator.
• Configure Public Access Printers for your computers to print from.
Creating a NDPS Manager
1. Log on to a NetWare 5.x file server as an Administrator.
2. Run the NetWare Administrator application Nwadmn32.exe, which should
be located in F:\public\win32 on your network. Otherwise, see your
NetWare user guide or your network administrator to find the file loca-
tion.
3. When the program runs, select the organization on NetWare
Administrator in which you want the NDPS Manager object to reside,
e.g., TeSupp.
4. Click on Create and select Object from the menu bar. The New Object
window appears.
5. Select NDPS Manager, which will bring up the Create NDPS Manager
Object window.
31