Linksys EFSP42 User Manual page 7

Getting to Know the 10/100 2-Port
Switched PrintServer (EFSP42)
The Front Panel LEDs (EFSP42)
The 10/100 2-Port Switched PrintServer LEDs
These 3 LEDs apply to the 2-Port Switched PrintServer only (EFSP42).
Link/Act Link/Act
Full/Col Full/Col
Full/Col LED is off, then the data is transmitting in half
duplex mode. If the green LED flickers, that connection is
experiencing collisions. Infrequent collisions are normal. If
the switch seems to experience excessive collisions, verify
that your network cabling is securely crimped and installed
correctly. If this LED flickers too often, see page 44 for
Troubleshooting.
100 The 100 LED lights up orange when a successful 100Mbps
connection is made through that port. When the 100 LED
is off, then the data transfer rate is 10Mbps.
8
Instant EtherFast ® Series
. When this
EtherFast 10/100 PrintServers
The Rear Panel Ports
The 10/100 2-Port Switched PrintServer Ports
Power Port This port on the back of your unit connects your
Switch's AC Power cord.
Parallel 1, Parallel 2 These two Parallel (LPT) Ports connect to your
printers.
Uplink Port
The Uplink Port, which is shared with Port 1, con-
nects to a standard RJ-45 port on another switch,
hub, or router to expand your network.
Ports 1 to 4
These four ethernet RJ-45 Ports connect to your
network devices, such as PCs, other print servers,
remote hard drives, and any other networkable
device. Use Cat 5 UTP cabling with these ports.
9