Table of Contents
Advertisement
via SMS
4.5 LoRa D2DSettings (LoRaWAN Version Only)
LoRa D2D protocol is developed by Linovision and used for setting up transmission
among Linovision devices without gateway. When the LoRa D2D setting is enabled, IOT-300 can
work as a LoRa D2D controller to send control commands to other devices or work as a LoRa
D2D agent to receive commands to trigger the DO or RS485 devices.
1. Go to "General ->Basic" page, enable LoRa D2D feature, define a unique LoRa D2D k
ey which is the same as LoRa D2D controller or agent devices. (Default LoRa D2D Key:
5572404C696E6B4C6F52613230313823)
2. Go to "LoRaWAN Settings ->Basic" to configure the RX2 datarate and RX2 frequency. When
IOT-300 works as LoRa D2Dcontroller,it will send commands as RX2 settings.
3. Go to "Command" page to set corresponding operations.
When DI triggers, IOT-300-LORA can work as LoRa D2D controller to send control command to
control
23
Ω8
Advertisement
Table of Contents
