LINOVISION IOT-C300-LORA Quick Start Manual page 22

When pulse counter reaches a specific value. This only works when DI works
Counter
as counter mode.
When the value reaches any threshold.
Is continuedfor: the analog value should last for some time.
Set lockout time: after the lockout time, IOT-C300-LORA device will detect
Channel/4-20m
if analog value matches the condition. 0 means this IF condition will only
be detected once.
A/0-10V/PT100
Note: for IOT-C300 cellular version, if this Modbus channel quantity is more
than 1, this condition will only judge the first value.
Received a
When IOT-C300-LORA device receive a specific message from
message
server.
The Device
Reboot the device.
Restarts
Received a D2D
This only works with IOT-C300-LORA version and the LoRa D2D feature
control
is enabled. See details on
command
When IOT-C300-LORA cellular signal is lower than 10 asu, this only
The signal
works with IOT-300 cellular version.
strength is weak
3. Set THEN action according to your request. You can add at most 3 actions in one command.
Action
Send a custom
Send a custom message to the server.
message
DO can be set to normally open/normallyclosed/change status.
Output Trigger DelayTime: this action will trigger after a specific time;
Duration:the output status will last for a specific time, 0 means permanent.
Restart the Device Reboot the device.
This only works with IOT-C300-LORA version and the LoRa D2Dfeature
Send a D2Dcontrol
is enabled. See details on
command
Send a Modbus
This only works with IOT-C300-LORA version and the LoRa D2Dfeature
command via
is enabled. See details on
RS485 interface
This only works with IOT-C300 cellular version and the SMS Report feature
Send a device
is enabled.
status message
chapter 4.5.
Description
chapter 4.5.
chapter 4.5.
22