Table of Contents
Advertisement
Parameters
Enable
Enable digital input to detect status and upload the data.
Digital Input
Fetch
Click to get the current inputstatus.
Counter
Digital Filter
Itʼs recommended to enable when pulse period is greater than 250 us.
Click to start/stop counting. Note that IOT-C300-LoRaWAN
Start/Stop
non-changeable counting values if you do not click "Start".
Refresh
Refresh to get latest counter values.
Clear
Count the value from 0.
Note: the countingvalue will lose if IOT-C300-LoRaWAN
4.3.3 Digital OutputSettings
IOT-C300-LoRaWAN
®
supports 2 digital outputs to control the devices.
Parameters
Enable the digital output to control the device and upload changed
Enable
status.
When Power is
After the device power is restored, the DO status will return to normally
Restored, DO
closed or normally open according to this parameter.
Fetch
Click to get the current outputstatus.
Switch
Click to change the DO status.
4.3.4 RS485 Settings
IOT-C300-LoRaWAN
®
has one RS485 port for Modbus RTU device connection.
1. Connect RS485 device to RS485 port.
2. Go to "General ->RS485" to enable RS485 and configure serial port settings. Serial port
Description
®
loses the power.
Description
®
will send
15
Advertisement
Table of Contents
