Port 13 & 14: Configuration/Status: Sfp+ Ports - Acuity Brands Lighting Pathway VIA 12 Series User Manual

Range is from 10Mb – Half Duplex (a common value for older devices) to 1Gb – Full Duplex. The port may also be disabled.
NOTE: It is not possible to force a device to connect at a speed faster than the device's network interface hardware will
support.
BANDWIDTH USE
Shows bandwidth used on the selected port as a percentage value. Bandwidth is relative to the port speed as negotiated
by the link partner, i.e. if the port is set to 100Mbit, a bandwidth use of 55% is equal to approximately 55Mbit of traffic per
second.
This menu item is read-only.
CURRENT MULTICAST GROUPS
Displays a list of the multicast addresses used by the end device connected to the selected port.
It is not possible to block a specific multicast group. The menu list is read-only.
PORT 13 & 14: CONFIGURATION/STATUS: SFP+ PORTS
Ports 13 and 14 are SFP+ ports. These behave the in the same manner as ports 1-12 for configuration from the front UI
menu, however have slightly different menu items.
Menu Item
SFP Module
REV 1.0 • June 2020
Port <x> Configuration
SFP Module: 10GBase-SR
Link Mode: 10G Full Duplex
VLAN: Tagged (Uplink)
Bandwidth Use: 1%
Current Multicast Groups
Shows the type of SFP/SFP+ module detected. Read-only.
Not Detected: No module inserted
Not Support: Module is not compatible/supported
1000Base-SX: Module is recognized as 1000Base-SX
1000Base-LX: Module is recognized as 1000Base-LX
10GBase-SR: Module is recgonized as 10GBase-SR
10GBase-LR: Module is recognized as 10GBase-LR
Dual Rate 1/10G Multi Mode: Module is recognized as Dual-rate 1/10G Multi-mode.
VIA12 [6750, 6750-P, 6752-P, 6754-P] - Manual
<Back>
Description
60