Sfp+ Ports; Opticalcon Ports; Power Connections; Configuration - Acuity Brands Lighting Pathway VIA 12 Series User Manual

SFP+ PORTS

Models 6750 and 6750-P have two SFP+ compatible ports on the rear of the device. These require the user to provide an
SFP or SFP+ fiber transceiver to allow connection to fiber networks. See Appendix 1: SFP+ Fiber Adapter Selection for
more information on selecting a fiber transceiver.
The user may also use SFP+ Direct Attach cables, both active and passive. This is often the easiet and lowest-cost way to
connect multiple switches together, if they are close together in the same enclosure or rack.

opticalCON PORTS

Models 6752-P and 6754-P have opticalCON DUO and opticalCON QUAD ports, respectively, for multimode fiber cables
installed instead of SFP+ ports. Additional SFP+ transceivers are not required.

POWER CONNECTIONS

The IEC power plug or powerCON AC Input plug may be connected to an AC power source with a voltage between 100
and 240VAC, either 50 or 60 Hz.
Models 6752-P and 6754-P have an additional powerCON THRU connector to simplify mains power connections in a rack.
DO NOT EXCEED 10A DRAW ON THE FIRST SWITCH. The powerCON THRU jumper cable is not provided.

CONFIGURATION

Models 6750, 6750-P, 6752-P and 6754-P may be configured from the front panel interface using the LCD and rotary
pushbutton encoder. However, we recommend using our free software tool, Pathscape, if possible. To download Pathscape,
visit the Pathway website at
download link for the appropriate operating system. Use the QR Code below to visit the download page.
For instructions on how to set properties and send transactions to devices, refer to the Pathscape manual.
For instructions on using the LCD and encoder to navigate the switch menus, see the Front Panel UI and Menu section.
5
https://www.pathwayconnect.com/index.php/products/software/176-pathscape
VIA12 [6750, 6750-P, 6752-P, 6754-P] - Manual
and click the
REV 1.0 • June 2020