Linksys Etherfast EF1704 User Manual page 34

OSPF Host Route Configuration
The OSPF Host Route Configuration screen, shown in Figure 6-51,
allows you to configure the OSPF host route parameters.
• IP Address - The IP address applied for this interface.
• Cost - The cost of sending a packet on the interface, expressed in the
link state metric.
• Area ID - The OSPF area to which the attached network belongs to.
Select Apply to make changes. Select OK to return to the previous panel.
Select Cancel to cancel any changes. Select Prev Page to view the previous
page. Select Next Page to view the next page. To display a specific page, set
the page number in the Page field and then press Apply. Select Add to add a
host route.
61
Instant EtherFast
Figure 6-51
Series EtherFast Layer 3 Management 4-Port Gigabit Ethernet Switch
® ®
Add OSPF Host Route
The Add OSPF Host Route screen, shown in Figure 6-52, allows you
to add an OSPF host route.
• IP Address - The IP address applied for this interface.
• Cost - The cost of sending a packet on the interface, expressed in the
link state metric.
• Area ID - The OSPF area to which the attached network belongs to.
Select OK to return to the previous panel. Select Cancel to cancel any changes.
Figure 6-52
62