Linksys Etherfast EF1704 User Manual page 18

Layer 3 management 4-port gigabit ethernet switch instant etherfast series
Hide thumbs Also See for Etherfast EF1704:
Table of Contents

Advertisement

Layer 2 Menu
The Layer 2 Menu, shown in Figure 6-19, contains options for port configura-
tion, port mirroring, and port trunking.
• Port Configuration - Enables any port, enables/disables flow control,
and sets communication mode to auto-negotiation, full duplex, or half
duplex.
• Mirror Port Configuration - Sets the source and target ports for mir-
roring.
• Port Trunking Configuration - Specifies ports to group into aggregate
trunks.
• Static Unicast Address Configuration - Used to manually configure
host MAC addresses in the unicast table.
• Static Multicast Address Configuration - Used to manually configure
host MAC addresses in the multicast table.
Select OK to return to the previous panel.
29
Instant EtherFast
Figure 6-19
Series
EtherFast
Layer 3 Management 4-Port Gigabit Ethernet Switch
®
®
Port Configuration
The Port Configuration screen, shown in Figure 6-20, lets you display or set
communication parameters for any port on the Switch, including adminis-
trative status, auto-negotiation, default communication speed and duplex
mode, as well as flow control in use.
• Port (#) - Number of the port.
• Link Status - Indicates if the port has a valid connection to an
external device.
• Admin Status - Allows you to enable or disable administrative rights per
port.
• Auto Negotiate - Enables or disables auto-negotiation for port speed,
duplex mode, and flow control.
• Default Type - If auto-negotiation is disabled, the port will be set to the
indicated speed and duplex mode.
• Current Type - Indicates the current speed and duplex mode of each port.
Port Configuration
• Flow Control - Used to enable or disable flow control under the "Config"
heading. Flow control can eliminate frame loss by "blocking" traffic from
end stations or segments connected directly to the Switch when its buffers
fill. When enabled, back pressure is used for half duplex and IEEE 802.3x
for full duplex.
Note: Flow control should not be used (set to OFF under "Status") if a port
is connected to a hub.
Figure 6-20
30

Advertisement

Table of Contents
loading

Table of Contents