Linksys Etherfast EF1704 User Manual page 14

SNMP Configuration
The SNMP Configuration screen, shown in Figure 6-11, displays parameters
for the Simple Network Management Protocol (SNMP).
• Send Authentication Fail Traps - Issue a trap message to a specified IP trap
managers whenever authentication of an SNMP request fails. Default is
enabled.
• SNMP Communities - Assigns SNMP access based on specified strings.
• IP Trap Managers - Specifies management stations that will receive authen-
tication failure messages or other trap messages from the Switch.
Select OK to return to the previous panel.
21
Instant EtherFast
Figure 6-11
Series EtherFast Layer 3 Management 4-Port Gigabit Ethernet Switch
® ®
SNMP Communities
The SNMP Communities screen, shown in Figure 6-12, allows you to con-
figure the community strings authorized for management access. Up to five
community names may be entered.
• Community Name - A community entry authorized for management
access. Maximum string length is 19 characters.
• Access - Management access is restricted to Read Only or Read/Write.
• Status - Sets administrative status of entry to enabled or disabled.
Select Apply to make changes. Select OK to return to the previous panel.
Select Cancel to cancel any changes.
Figure 6-12
22