Linksys Etherfast EF1704 User Manual page 28

• Transit Delay - The estimated number of seconds it takes to transmit
a Link State Update Packet over this interface.
• Retransmit Interval - The number of seconds between LAS retrans-
missions, for adjacencies belonging to this interface.
• Hello Interval - The length of time, in seconds, between the Hello
Packets that the router sends on the interface.
• Dead Interval -After ceasing to hear a router's Hello Packets, the
number of seconds before its neighbors declare the router to be down.
• Poll Interval - After beginning to hear a router's Hello Packets, the
period of time after its neighbors declare the router to be up.
• Authentication Type - Identifies the authentication procedure to be
used on the attached network.
• Authentication Key- The configured data allows the authentication
procedure to verify OSPF protocol packets received over the interface.
Select Apply to make changes. Select OK to return to the previous panel.
Select Cancel to cancel any changes.
Subnet Configuration: Modify DVMRP Configuration
The Subnet Configuration: Modify DVMRP Configuration screen ,
shown in Figure 6-39, allows you to modify the DVMRP parameters.
49
Instant EtherFast
Figure 6-39
Series EtherFast Layer 3 Management 4-Port Gigabit Ethernet Switch
® ®
• Metrics - This value is used to select the best reverse path to networks
that are connected directly to an interface on the Switch.
• Probe Interval - The interval between sending neighbor probe mes-
sages to the multicast group address for all DVMRP users.
• Neighbor Timeout - The interval to wait without hearing from a
DVMRP neighbor before declaring it dead.
Select Apply to make changes. Select OK to return to the previous panel.
Select Cancel to cancel any changes.
Add Subnet
The Add Subnet screen, shown in Figure 6-40, allows you to add an
IP interface.
• VLAN - The VLAN associated with this IP interface.
• Select - Use this option to create or modify a VLAN.
• IP Address - The IP address associated with the specified VLAN
interface.
• Subnet Mask - A template that identifies the address bits in the
host address used for routing to specific subnets.
• Proxy ARP - Enable or disable the Proxy Address Resolution
Protocol.
Figure 6-40
50