Maintenance; Recycling; Ec Declaration Of Conformity; Designation Of Equipment - S&P MULTI-REG CONTROL 2841 Series Manual

7. MAINTENANCE

 Before handling the ventilator, make sure it is disconnected from the mains supply even if it
has previously been switched off. Prevent the possibility of anyone else connecting it while it
is being worked on.
 The apparatus must be regularly inspected. These inspections should be carried out bearing
in mind the ventilator's working conditions, in order to avoid dirt or dust accumulating on the
impeller, motor or back-draught shutter. This could be dangerous and perceptibly shorten the
working life of the ventilator unit.
 While cleaning, great care should be taken not to unbalance the impeller or motor.
 All maintenance and repair work should be carried out in strict compliance with each country's
current safety regulations.

8. RECYCLING

 EEC Standards, together with the responsibility we should assume with future generations in
mind, oblige us to recycle all the materials we can. Therefore, please deposit all left-over
material and packaging in their corresponding recycling containers and hand in the replaced
machines to the nearest handler of this type of waste product.
 If you have any queries about S&P products, please contact our after-sales service at your local
S&P dealer. If in doubt, please visit our website at www.solerpalau.co.uk

9. EC DECLARATION OF CONFORMITY

 Herewith we declare that the fan/control designated below, on the basis of its design and
construction in the form brought onto the market by us is, in accordance with the relevant EC
Council Directives on Electromagnetic Compatibility. If alterations are made to the apparatus
without prior consultations with us, this declaration becomes invalid. We further declare that
the equipment identified below may be intended to be assembled with other
equipment/machines to constitute machinery, which shall not be put into service until the
assembled machinery has been declared in conformity with the provisions of these relevant EC
Council Directives.

10. DESIGNATION OF EQUIPMENT

 Relevant EC Council Directives, Electromagnetic Compatibility Directive (89/336/EEC.) Applied
Harmonised standards in particular BS EN 50081-1:1992, BS EN50082-1:1998, BS EN 61000-
3-2: 1995, BS EN 61000-3-3:1995
Page 22 of 24