Table of Contents
Advertisement
10.6 Option PROFIBUS Interface
10.6.1 LED's (Operation Status and Messages)
The LED's located on the top side, a green LED (Bus Run) and a red LED (Bus Fail), serve for monitoring of op-
erating status. For setting the address are two rotary coding switches located on the top next to the LED's
BUS RUN
ON
OFF
Flashes cyclic
Flashes irregular
BUS FAIL
ON
OFF
Flashing
10.6.2 Settings
10.6.2.1 Address Settings
The address settings are done with the coding switches on top of the housing. The higher decade with the cod-
ing switch MSD and the low decade with the coding switch LSD.
Figure 34: Address Adjustment and LED Signaling
10.6.2.2 Parameter Settings
The following parameters can be configured by GSD File
(GSD File is delivered as CD-ROM).
Table 9: Parameter Adjustment by GSD File
Function
Monoflop
Clock quantity SSI
Scale SSI/x
Offset
GREEN
= Ready
= Supply voltage not provided
= Slave has no cyclic data exchange with PROFIBUS-DP-MASTER
= start: Missing or faulty configuration
Runtime: Host watchdog- time error
RED
= unrecoverable Converter – Fault
= no error / bus in cycle
= Converter not addressed by the master
LED
ERROR (red)
RUN (green)
MSD
Setting Range
20 ... 255 µs
18 ... 32
1 ... 255
-1073741823 ... 1073741824
LSD
- 36 -
Connections and Interfaces
Factory Setting
[200]
[24]
[1]
[0]
Advertisement
Table of Contents
