Safety; Intended Use And Foreseeable Misuse - Leuze electronic SOLID-2SF-M Original Operating Instructions

Safety

2 Safety
Before using the safety sensor, a risk assessment must be performed according to valid standards (e.g.
EN ISO 14121, EN ISO 12100-1, EN ISO 13849-1, IEC 61508, EN 62061). The result of the risk assess-
ment determines the required safety level of the safety sensor (see table 2.1). For mounting, operating and
testing, document "SOLID-2SF-M, Optoelectronic delivery guarding of sheet-fed printing machines" as
well as all applicable national and international standards, regulations, rules and directives must be
observed. Relevant and supplied documents must be observed, printed and handed to the affected
personnel.
Before working with the safety sensor, completely read and observe the documents applicable to your
task.
In particular, the following national and international legal regulations apply for the commissioning, tech-
nical inspections and work with safety sensors:
• Machinery directive 2006/42/EC
• Low voltage directive 2006/95/EC
• Electromagnetic compatibility 2004/108/EC
• Use of work equipment directive 89/655/EEC supplemented by directive 95/63 EC
• OSHA 1910 sub-part 0
• Safety regulations
• Accident-prevention regulations and safety rules
• Ordinance on Industrial Safety and Health and employment protection act
• Device Safety Act
NOTE
Local agencies can also provide safety-relevant information (e.g. occupational safety and health
inspectorate, employer's liability insurance association, labor inspectorate, OSHA).
2.1

Intended use and foreseeable misuse

WARNING!
A running machine can cause severe injuries!
 Make certain that, during all conversions, maintenance work and inspections, the system is
securely shut down and protected against being restarted.
Leuze electronic GmbH + Co. KG SOLID-2SF-M 8