Signal Input Transmitter; Transistor Outputs, Receiver - Leuze electronic SOLID-2SF-M Original Operating Instructions

Technical data
Protection class (VDE 106)
Degree of protection
Ambient temperature, operation
Ambient temperature, storage
Relative humidity
*) The circuits connected to inputs and outputs must comply with the air and creepage gaps stipulated for safe isolation in
the relevant standards.
Table 8.2:
8.1.4

Signal input transmitter

Test input
Table 8.3:
8.1.5

Transistor outputs, receiver

Dyn SSD/SSD transistor outputs
Switching voltage low
(beam not interrupted)
Switching current
Load capacity
Permissible wire resistance for load
Permissible conductor cross section:
receiver
Permissible cable length between
receiver and load
Help impulse width
Help pulse distance
Channel 1
Channel 2
SSD restart delay time after beam
interruption
SSD response time
Beams 1-3
Beam 4 (if available)
Dyn SSD switching frequency
Dyn SSD signal delay after switch-on/
autoreset
*) Note the additional restrictions due to cable length and load current
Table 8.4:
Leuze electronic GmbH + Co. KG
General system data
Input: Contact or transistor against +24 V DC current load: 20 mA max.
Signal input transmitter
Transistor outputs, receiver
III
*)
IP 65
0 ... 50 °C
-25 ... 70 °C
15 ... 95%
5 npn safety-related transistor outputs, short-circuit proof
Minimum
-
-
-
-
-
3.3 Hz (300 ms pulse width) +/-10%
3 sec
SOLID-2SF-M
Typical Maximum
GND+
15 VDC
35 mA
< 30nF
< 50
-
0.14 mm²
- 100 m
<40 µs
6.5ms
6.2ms
100 ms
130 ms
30 ms 34 ms
*)

-
-
-
24