Start-Up; Cleaning The Machine; Check The Operating Fluid Levels And Replenish, If Necessary - Index R300 Operating Instructions Manual

START-UP

Transport, Installation, Start-up
R300
LR1802.10081 - 06.11.2014
Start-up
This section lists all the actions that must be carried out in the order given before
the machine is ready for start-up.
Only then the machine is ready for operation.

Cleaning the Machine

All blank parts of the machine were treated by spray-covering with an anti-rust
agent. Usually this protective cover is flushed away by the coolant during the opera-
tion of the machine.
To prevent solvent splashes from entering the eyes when
cleaning the machine, be sure to wear suitable protective
goggles.
For cleaning the inside of the machine's working area, protect
your hands and arms by wearing clothes with long sleeves and
suitable gloves.
Risk of injury by sharp machine parts and tool edges!
The anti-rust agent must be washed off, if the machine is put into operation only
after a long time so that the protective layer has become very tough.
The mounting surfaces for tool holders and accessories must also be cleaned.
For this purpose, only solvents may be used that do not affect the machine paint.
Suitable solutions are turpentine, petroleum or benzine.
Check the Operating Fluid Levels and Replenish, if Nec-
essary.
Hydraulic system: .......................................................... Oil level check
Cooling lubricant unit: .................................................... Replenish cooling lubricant
Centralized lubrication: ................................................... Oil level check
Auxiliary equipment: ...................................................... Oil level check
For information on the lubricating oil, hydraulic fluid and cooling lubri-
cant grades, as well as on volumes and filling positions, see Docu-
ment "Notes on Operating Materials" and the machine installation
chart in Chapter "Working Documents".
31