Canon VB-H47 Installation Manual page 22

Safety Precautions
Important
• Installation of a lightning arrester (a surge protection device) is recommended as a
measure against failures caused by lightning strikes.
• Do not hold the device by the camera head.
• Never touch the camera head during initialization.
• Do not turn the camera rotator by hand.
• Do not install the camera on an unstable surface.
• Make sure the camera is installed ±5° or less from the horizontal position.
• The camera can be installed and used in the upright position. Attach commercially
available anti-slip guards to the base of the camera and set on a flat, stable surface
without inclination, or fix the camera to a tripod, etc. Be sure to use a tripod with
mounting screws shorter than 5.5 mm (0.22 in.). Using a tripod with mounting
screws 5.5 mm (0.22 in.) or longer may damage the camera. Also, use a tripod with
a base diameter of 30 mm (1.18 in.) or more.
• After turning off the power, do not turn the power on again for at least five
seconds.
• Take measures to remove static electricity before performing any procedures.
• If there is condensation, wait to power on until the condensation dissipates.
22