Bosch MIC inteox 7100i User Manual page 87

MIC inteox 7100i
Status
Code
5
6
7
8
9
Bosch Security Systems
Description
When operating using redundant
power sources, the camerais
detecting insufficient voltage being
provided by the external High PoE
power source.
When operating using redundant
power sources, the camera is
detecting insufficient voltage being
provided by the external 24 VAC
power source.
Camera may be operating in an
environment where ambient
temperature is below the
specification of the camera.
Camera may be operating in an
environment where ambient
temperature is above specification
of the camera.
Camera has been subjected to high
shock. Mechanical damage to the
camera may exist.
User Manual
Recommended action
(to be completed by a qualified Service
Technician)
1. Verify that the High PoE power source
(midspan or switch) can provide 95 W of
output power.
2. Verify that the network cable is not longer
than 100 m maximum.
3. If using the 95W High PoE Midspan
(NPD-9501A), verify that both LEDs are
green. If not, refer to the "Troubleshooting"
section of the installation manual of the
midspan.
1. Verify that the 24 VAC power source can
provide at least 4.0 A to the camera.
2. Verify that the wire gage of the power
cable is sufficient for the distance between
the power source and the camera and that
the voltage getting to the user cable of the
camera is between 21 VAC and 30 VAC.
1. Verify that the ambient temperature is not
below -40 °C (-40 °F).
2. Review the diagnostic log of the camera
(accessible from the Service menu) for errors
related to the operation of the internal
heaters.
Note: Motorized zoom and focus functions of
the visible camera lens will be disabled until
the camera operates within the specified
temperature range.
1. Verify that the ambient temperature is not
above +65 °C (+149 °F).
2. Review the diagnostic log of the camera
(accessible from the Service menu) for errors
related to the operation of the internal fan.
3. Add the optional sunshield accessory to
reduce internal heating caused by sun
loading.
1. Verify the integrity of the mechanical parts
such as the arms and the pan body.
2. Verify the integrity/tightness of the
external fasteners. Tighten where necessary.
3. If obvious damage is present, stop using
the camera and contact the nearest Bosch
Security Systems Service Center.
Status codes | en 87
2022-09 | 1.18 |