Magic Chef MCSDW8TCST User Manual page 5

25. Under certain conditions, hydrogen gas may be produced in a hot water system that has not been used for two weeks or
more. HYDROGEN GAS IS EXPLOSIVE. If the hot-water system has not been used for such a period, before using the
dishwasher turn on all hot-water faucets and let the water flow from each for several minutes. This will release any
accumulated hydrogen gas. As the gas is flammable, do not smoke or use an open flame during this time.
26. Please check the water supply line periodically. It is susceptible to breakage. It becomes less flexible as time goes by.
Replace it immediately when it is torn, cut, swollen or there is water leakage.
RECYCLING
Remove the door to the washing compartment when removing an old dishwasher from service or discarding it. Ensure that the
appliance presents no danger to children while being stored for disposal. Before disposing the dishwasher:
1. Disconnect the appliance from the mains supply.
2. Cut off the mains cable and discard it.
3. Remove the door catch to prevent children and pets to get closed in the appliance.
Old appliances may contain materials that can be recycled. Please contact your local recycling authority about the possibility
of recycling these materials.
Please check the water supply line periodically. It is susceptible to breakage. It becomes less flexible as time goes by. Replace
it immediately when it is torn, cut, swollen or there is water leakage.
Please keep the dishwasher package out of the reach of children after unpacking it.
WARNING: Risk of injury or suffocation! Ensure that any plastic wrappings, bags, small pieces etc. are disposed of safely
and kept out of the reach of children.
INSTALLATION
WARNING: When installing the dishwasher, follow basic precautions, including the following:
Please check the standards and local codes for placement of machine.
1. Installation, maintenance and repair should be performed by a qualified installer. Work by unqualified persons could
be dangerous and may void the warranty.
2. DO NOT operate the appliance if damaged, malfunctioning, partially disassembled or if it has missing or broken parts.
3. Before installation or service, disconnect the power supply to the work area by unplugging the unit, "tripping" the
circuit breaker or removing the fuse.
4. Only connect the dishwasher to the power supply when all installation and plumbing work is complete.
5. Never connect the ground wire to gas lines, or hot water pipes, plumbing lines.
6. DO NOT install or store the dishwasher where it can be exposed to below freezing temperatures or exposed to
weather.
7. Dishwasher must be secured to adjacent cabinetry using the brackets provided. Failure to do this may cause damage
to property or bodily injury.
8. Connect to a properly rated, protected and sized power supply circuit to avoid electrical overload. The dishwasher is
designed for an electrical supply of 120 V (volts), 60 Hz (hertz), AC, connected to a dishwasher-dedicated, properly
grounded electrical circuit with a fuse or breakers rated for 15 amperes. Electrical supply conductors shall be a minimum of
# 16 AWG copper wire rated at 75 °C (167 °F) or higher. These requirements must be met to prevent injury and machine
damage. Consult a qualified electrician if in doubt.
9. DO NOT use any extension cord or portable outlet device to connect the dishwasher to a power supply.
WARNING: Danger of suffocation! Ensure that any plastic wrappings, bags, small pieces etc. are disposed of safely and
kept out of the reach of children.
READ AND FOLLOW THIS
SAFETY INFORMATION CAREFULLY
SAVE THESE INSTRUCTIONS
5