Table of Contents
Advertisement
NOTE: While the Delay Timer function is activated, you cannot make changes to the wash program or auxiliary
functions for the duration of the delay.
NOTE: The delay timer cannot be set once a wash program has started.
To Cancel the delayed start function:
1. Open the door of the dishwasher.
2. Press and hold the 'Delay' button for 3 seconds.
3. After holding the button for 3 seconds the delayed start program will be canceled.
STARTING THE WASH CYCLE
Once the dishwasher is loaded and the wash program and auxiliary functions are selected, press the 'Start/Pause'
button and close the dishwasher door. When the washing program begins, the remaining time will show on the
display.
• DO NOT open the door of the dishwasher while a wash program is running. If the door is opened, the unit
will switch to standby and the program will stop. Press 'Start/Pause' and close the door within 4 seconds
to resume.
• If the door must be opened, immediately press the 'Start/Pause' button to pause the program. Press
again and close the door within 4 seconds to resume washing.
NOTE: Program and extra functions cannot be changed once the program has started.
CANCELLING THE WASH PROGRAM
To cancel the wash program after it has started, open the dishwasher door, then press and hold the "Program/
Cancel" button for 3 seconds. The display will show "1", then press the "Start / Pause + On/Off" button and close
the door within 4 seconds. The dishwasher will perform any functions necessary for cancelling the program. If
the door is not closed within 4 seconds after pressing the "Start/Pause + On/Off" button, cancelling of the
program will not start.
NOTE: Depending on the stage of the wash program the unit was currently in when the program is canceled,
there may be residual detergent or rinse aid on items.
END OF WASH PROGRAM
When the wash program is finished, "0" will be display and the unit will give an audible warning. Open the
door, then press and hold the 'On/Off' button for 3 seconds to turn off the dishwasher. Leave the dishes in
the unit with the door ajar for about 15 minutes to cool down and to finish drying.
WATER CUT-OFF WARNING
If mains water or water inlet tap is turned off, "FF" will flash continuously on the display. The dishwasher will
start a new wash program when the water supply is restored.
OVERFLOW WARNING
If the machine intakes too much water or there is leakage at any of the compo-nents then the machine will
detect this and "F1" will flash on the display. As long as the overflowing continues, safety algorithm will be active
and try to discharge the water. If overflowing stops and safety is assured, "F1" will disappear. If "F1" does not
disappear, there is a permanent fault. In this case, the authorized service should be contacted.
If the dishwasher detects that there is too much water or a leakage at any of the components, the display will
flash "F1" and the unit will attempt to discharge the water. When the overflow stops or the issue is fixed, the "F1"
will turn off. If the code remains, contact customer service for assistance.
18
Advertisement
Table of Contents
