Table of Contents
Advertisement
12-30V DC via direct wiring
To power your device via direct wiring, connect
the electrical wires from your low voltage
transformer to the 4-pin Phoenix pin plug
provided. Check the "+" and "-" marks on the back
of the device to make sure the wires are
connected in the right order, and fasten the
screws on the Phoenix pin plug to secure.
Run the wires through the opening on the back
plate and plug the 4-pin Phoenix pin plug into the
corresponding terminals on the back of the device.
IMPORTANT SAFEGUARDS
Please use a power source within the range of the product specification. Please
contact the facility manager or other responsible personnel if the power source
specification is not clear.
The device must be installed by certified
electricians or other authorized
personnel ONLY. When installing the
device, ALWAYS follow safety
precautions to reduce the risk of fire,
electric shock, and/or injury to persons.
Make sure the power is cut off before
proceeding!
Page 15
Advertisement
Table of Contents
