Table of Contents
Advertisement
CHAPTER 2 HARDWARE INSTALLATION
Remote On/Off: J10
The 2-pin connector must utilize a toggle switch (one push
on/second push off). To use this function an ATX or PS/2 with a
stand by +5V cable switch power is needed.
Remote ON/OFF and Soft Power Support
When connected to a momentary SPST switch, this 2-pin header is
used to power up the system. When used with a power supply that
supports remote power on/off the system board can be turned off by
three different methods: The front panel "Remote On/Off" switch, a
thermal trip signal from the Pentuim PROÔ, or a soft signal from
the Super I/O controller.
In "Soft Off," an APM command isssued to the system BIOS will
cause the power supply to turn off via the "PS ON"" control signal
on the power connector. For example WindowÔ 95 will issue this
APM command when the user clicks on the Shutdown icon. Power
can be restored via a front panel power button connected to the front
panel header.
USB Connector : USB
This 10-pin connector connects USB cable to support USB device.
2 - 16
Advertisement
Table of Contents
