Table of Contents
Advertisement
CHAPTER 2 HARDWARE INSTALLATION
The system board has a 32-bit Enhanced PCI IDE Controller that
provides for two HDD connectors, IDE1 (primary) and IDE2
(secondary). You can connect up to four hard disk drives or devices
to IDE1 and IDE2.
IDE1 (Pimary IDE Connector)
If you only use one hard disk you must connect to IDE1. You can
also connect two hard disks, a Master drive and a Slave drive to
IDE1.
IDE2 (Secondary IDE Connector)
(see preceding figure)
If you use two hard disks, you can connect one to HDD1 and the
other to HDD2. However, you must use a driver program for the
hard disk connected to IDE2. You can also connect two hard disks
to HDD2, a Master drive and a Slave drive.
CPU Fan Connector: JFAN
This 2-pin connector connects a power source of +12V with your
CPU's cooling fan. Check the voltage range and polarity of your
cooling fan before you connect it.
2 - 14
Advertisement
Table of Contents
