Table of Contents
Advertisement
一、Precautions for use
Please read the manual thoroughly before use, misoperation may
cause damage to the DLP projector.
Attention
1. Optical module is fragile product, no dropping and disassembly is allowed.
2. Please power the optical module with 12V and higher than 4A power source.
3. Do not detach DMD FPC.
4. Please take anti-static measures before use
5. The optical module has only blue light source, do not enable red or green light
source.
6. Be aware of short circuit while wiring the optical module to other equipment.
7. This module will automatically power on when connected to power source.
Please contact us if not work properly.
8. Please read through the instructions before use. Misoperation may cause damage
to the module.
9. Please pay attention to anti-static measures before use. Static electricity will
cause damage to the main chip or DMD.
10. Before powering on, check whether there is overlap of the metal part of the IO
wire or foreign matter on the PCB board. The overlap of the bare IO wire or the
conductive foreign matter on the PCB board may cause a short circuit and cause
damage to the PCB board.
11. The power of the light source of this DLP projector is high.It is forbidden to
power on machine without connecting the radiator, the light source may burn out
within a few seconds.
Note:
the GUI version used in this document is 2.2.0.6 and the operating system is
win10 x64.
1
Advertisement
Table of Contents
