How To Modify The Specifications Of Test Patterns - BOPIXEL OPR305 Series Operating Manual

select "Active High" or "Active low", and click the "Set" button. After the setting
is successful, you need to click "Run Continuously" button. After clicking the
button, the external trigger input will drive the module to project an image.
"Run Once" button can also trigger, but it will cause a projection error. The
external trigger can only project one image at a time, and the projection
order is the set pattern order.

5.3 How to Modify the Specifications of Test Patterns?

(1) Connect the module to the computer, and ensure that the module is properly
connected to the GUI. Click the "Display" button on the left, configure as shown
in the figure below, and click "Set" twice to make the setting take effect (if the
current working mode is not "video" mode, it needs to be clicked twice to take
effect).
33
Using