一、Precautions For Use - BOPIXEL OPR405 Series Operating Manual

一、Precautions for use
Please read the manual thoroughly before use, misoperation may
cause damage to the DLP projector.
1. The DLP projector contains optical components, and the PCB board leaks out, so
it cannot be dropped from a high place.
2. Do not use more than 120W power consumption. It may cause accidents such as
overheating and fusing of the connecting wire.
3. This DLP projector is a high-power module. All three lights are on and the
maximum current may reach more than 100W. The insufficient power supply
capacity of the power supply equipment may cause the module to restart.
4. This DLP projector contains high-precision optical components, which cannot be
disassembled without authorization.
5. The DLP projector is powered by a 12V power supply and can be powered by a
12V 4A or higher current adapter.
6. The DMD cable connector has a limited service life, so do not unplug the cable
without authorization.
7. It is strictly forbidden to unplug the DMD cable when the device is powered on,
as there is a high probability that the DMD will be damaged.
8. Please pay attention to anti-static measures before use. Static electricity will
cause damage to the main chip or DMD.
9. Before powering on, check whether there is overlap of the metal part of the IO
wire or foreign matter on the PCB board. The overlap of the bare IO wire or the
conductive foreign matter on the PCB board may cause a short circuit and cause
damage to the PCB board.
10. The power of the light source of this DLP projector is high.It is forbidden to
power on machine without connecting the radiator, the light source may burn out
within a few seconds.
The DLP projector is turned on when it is powered on. If it does not work
11.
properly, please contact us.
1