Lexicon RV-5 Supplementary Manual page 4

Partner: Lexicon
Model: RV-5 Receiver
Device Type: Receiver/Processor
Input_*_Zone_2
Auto_EQ_On/Off
Tone_On/Off
Analog_In
Digital_In
Two_Line_OSD_Toggle
V-Process_Toggle
EQ_HF_Shelf_+/-dB
FM/AM_Band
Tuner_Stereo/Mono
Tuner_Tune_Auto/Manual
*_Direct_Setting_Enable
Key_*
Two_Line_OSD_Off
Auto_Feedback_On/Off
Two_Line_OSD_*_Sec
Front_Panel_LCD_Display_Bright_Full/Half/Off
Video_Process_Conversion_On/Faroudja/Bypass
Bass_+1/-1_dB
Poll_Enable
From_Device$
D Pulse to pick a source input for Zone 2 (Main).
D Pulse for Auto EQ.
D Pulse for tone.
D Pulse to set analog in.
D Pulse to set digital in.
D Pulse to set two line OSD state.
D Pulse to set Video process state.
D Pulse to increment/decrement EQ HF in 1 dB increments.
D Pulse to set tuner band state to either FM or AM.
D Pulse to set tuner state to either stereo or monaural.
D Pulse to set tuner state to either auto or manual.
Pulse one of these inputs to enable commands such as Main Volume,
Zone 2 Volume, Bass, Treble, HQ Shelf, FL Trim, etc. After a Direct
D
Setting function is selected, the Key_* functions are used to set proposed
level. Press Key_Enter to send command.
D Press to adjust direct setting selected. Key_Clear/Up/Down/Enter.
D Pulse to change two lines of OSD display to off.
D Set Auto_Feedback_On high to enable auto feedback.
D Pulse to change two lines of OSD display to various durations in seconds.
D Pulse to change brightness level of FRONT_PANEL_LCD_DISPLAY.
D Pulse to set video process conversion mode.
D Pulse to increment/decrement bass level by 1 dB.
Hold high to enable polling of unit for it's settings every .5 seconds. Hold
D low to disable polling when not visiting pages directly related to control of
the receiver/processor.
S Serial signal to be routed from a 2-way RS232 port or TCP/IP Client.