Table of Contents
Advertisement
Contents Explanation of LCD Indicator
Displayed contents explanation of LCD information representation indicator
Function selection
You can select any work you want by pushing
displayed in
of the above screen. You can choose 5 functions : REGENERATION, CHARGE, POWER SUPPLY, DISCHARGE, CONDITION TEST.
Battery Voltage / CV
Regeneration Mode
/
Charge Mode
Choose the working standard(official) battery voltage by using
You can choose 6V, 8V and 12V and go on to the next work by pushing
Discharge Mode
: Input final discharge voltage (CV; Cut off Voltage) by using
the arrow ( ). After set-up CV, go on to the next work by using
Capacity (Ah) / Current (A)
Regeneration Mode
/
Charge Mode
under the SET located the arrow ( ). After set-up the Capacity, go on to the next work by using
:
Power Supply Mode
Designate working battery hourly supply current(A) by using
the arrow ( ). Normally set-up 1/10 (10% of Capacity) carrying Current(A) of Battery Capacity(Ah).
Discharge Mode
: Designate working battery discharge current(A) by using
the arrow ( ). (The international standard discharge current of Car battery is 25A.) After set-up CV, go on to the
next work by using
Run Time (H:M)
Regeneration Mode
/
Charge Mode
:
Power Supply Mode
You can set up working battery progress time by using
working time according to the condition of the battery to be regenerated or charged.
Discharge Mode
: You can set-up discharge time by using
(Car battery doesn't need to designate discharge time). After designation go on to the next work by using
I R
/ CCA Regardless of function selection connect the machine and the battery, after pushing
check the connected battery's IR(Internal Resistance) value and CCA (Cold Cranking Ampere). These are current battery
conditions(Before). After finishing the work, IR value and CCA value are displayed automatically in After part.
These are regenerated (or charged) battery conditions(After).
Message
Work progress indication and warning message are displayed. Refer to the below items.
This message is appeared when the regeneration/charge time is passed because the supplying current is less than
set-up battery capacity or the battery cannot accept current due to the bad condition. If the battery doesn't make the
heat (lower than 45 ), the battery specification can be enhanced if you regeneration/charge again.
(Bad Judgement) That is a message displayed stopping the work when the battery voltage does not rise after a while
That is a message when the supplied current is 130% over than the total capacity of the battery with over supplying.
That is a message when the displayed battery voltage is 30% less than the set-up standard(official) voltage.
That is a message when there is no voltage, the wrong connection of +, - to the battery or one or both terminals
are disconnected due to external shock in machine working.
(Machine Problem) That is a message when the heat protection cannot be made because of the heat sink's
/
Power Supply Mode
/
Condition Test
UP button or
/
Condition Test
Set-up the Battery Capacity(Ah) by using
:
ENTER button.
In regeneration mode working time is displayed in SET part automatically, the elapsed time is
:
displayed in WORK part.
UP button or
These messages are appeared finishing the work completely.
from regeneration or charge started. This is a damaged battery to be a disposal.
temperature is risen during regeneration/charge/discharge work.
SELECT button, that function is
:
DOWN button under the SET located the arrow ( ).
ENTER button.
Condition Test
UP button or
DOWN button under the SET located
ENTER button.
UP button or
UP button or
DOWN button under the SET located
UP button or
DOWN button under the SET located
UP button or
DOWN button. You have to set up
DOWN button under the SET located the arrow.
ENTER button about 2 seconds, you can
is 12V Only.
DOWN button
ENTER button.
ENTER button.
6
Advertisement
Table of Contents
